Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

User

trevor gorniak

Joined on the:

Sep. 25, 2011

Score

2230

Comment(s)

7

Voted question(s)

2

Voted answer(s)

1

Votes up

0

Votes down

3

Votes up received

1

Votes down received

1

Recent Activity

Question(s) asked

7

Answered question(s)

24

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask a question
RECENT ACTIVITY QUESTION(S) ASKED ANSWERED QUESTION(S) COMMENTED QUESTION(S)

03/01/2021

 Ford Vincent Viteritto (130Pts.)

0

2005 ford escape does not crank ?

I installed a EVO ONE with a RF 642w . Everything works locks,unlock,alarm.. When i went to actavate the remote start the parking light comes on as if its going to crank but does not ,parking light flashes 4 times then it try's to start again and fails to crank parking lights flash again 4 times . Then it stops . please help me
Login to reply View 1 answer(s)

31/12/2020

 Honda jatinder girn (160Pts.)

0

Yellow wire on Evo start 2

Hi Where to connect yellow wire for evo start 2 , im using evo one and Hon2 Tharness 2014 honda crv, key start
Login to reply View 1 answer(s)

31/12/2020

 GMC Tyrell Gray (130Pts.)

0

EVO-ALL won’t switch from yellow light to red light after I start engine during programming.

2018 GMC Terrain using EVO-ALL and thar-gm6, yellow light turns solid but won’t switch to red while programming, tried reset and re flashing but still won’t work, light blue is connected to light blue/black.
Login to reply View 1 answer(s)

27/12/2020

 Cadillac Brian Pretzer (160Pts.)

0

3x lock on 2006 escalade?

installed evo one into 2006 cadallac escalade but unable to get factory 3x lock to activate the remote start function, is this not an option for this vehicle? Is an RF kit required if not? Is there a possible work around? (external remote start wire on evo one i can use?)
Login to reply View 2 answer(s)

27/12/2020

 Audi mason maas (130Pts.)

0

Help with programming

Following the steps to install and after i have the t harness installed the new firmware unloaded to the module hold the programming button until blue light plug in all connections press program one time lights should go off and come on on flashing blue and that's where i can't get the light to come back on... any idea what i am doing wrong
Login to reply View 1 answer(s)

26/12/2020

 Hyundai Eric Woleben (130Pts.)

0

2013 hyundai santa fe ignition on but no crank

Remote start is in and programmed. Evo all is programmed. 2013 hyundai santa fe push to start. Hit lock button 3 times, ignition on vehicle never cranks. I have rechecked all connections and they are good. At the end of the evo-all programming it says the red led should flash 10 times, then blue should flash fast, then red flash fast. Then turn ignition off. The red flash fast never happens. I dont know of that's related or not.
Login to reply View 1 answer(s)

26/12/2020

 Pontiac Steven Smith2 (130Pts.)

0

is there a t harness for an 2007 pontiac g5

is there a t harness for an 2007 pontiac g5
Login to reply View 1 answer(s)

20/12/2020

 Hyundai Stephen Renna (260Pts.)

0

What wire to use evo one to connect to clutch bypass. 2019 veloster n push to start

Clutch switch has a white, red and 2 black wires on it.
Login to reply View 1 answer(s)

18/12/2020

 Volkswagen Brian Sahid (420Pts.)

0

Golf Diesel Support

Loking to do a 2014 VW Golf Diesel. Is this doable using a EVO-ALL and TB-VW?
Login to reply View 1 answer(s)

18/12/2020

 Jeep Mehmet Corbaci (160Pts.)

0

I have 2006 Grand Cherokee 3.0 CRD.

I have 2006 Grand Cherokee 3.0 CRD. Which module should i buy?
Login to reply View 1 answer(s)

16/12/2020

 Dodge Dine Smith (130Pts.)

0

Which is the easiest/quickest installation, the EVO-All or EVO-One?

I'm looking for the easiest installation, as I have to do it outside and it's winter. And cold. And snowing. Which is the easiest/quickest installation, the EVO-All or EVO-One? I don't want to wire door or hood switches, I just want to install the remote start. I installed one (unfortunately can't remember which) on my Mom's Ford Taurus and it was very simple, very little wire splicing, etc. Would like to replicate that with the Dodge Ram. Thanks!
Login to reply View 1 answer(s)

21/11/2020

 Chevrolet trevor gorniak (2230Pts.)

0

radio stays on after remote shutdown

after remote start then shutdown with the remote the radio stays on unless you open the door install went good software level is 70.21 tried 70.18 radio stays on till door is openeded
Login to reply View 1 answer(s)

07/12/2019

 Subaru trevor gorniak (2230Pts.)

0

install 2020 subaru crosstrek

looking for a install solution for a 2020 crosstrek can you please advise if one will be available soon
Login to reply View 1 answer(s)

07/12/2019

 FAQ Aleks Gryshchenko (310Pts.)

0

What is recommended wire splicing method?

Hi all! I'd like to know recommended wire splicing method. I'm electrician and just got Evo-All and Flash-link plus separate remote starter to go into my wife's 2010 RAV4 (it has a dot on the key so no Evo-One for me...) Is soldering the best way? And then heat shrink? Or there is a better way? Thanks!!!
Login to reply View 1 answer(s)

23/11/2019

 Toyota Sam Howell (130Pts.)

0

2014 Toyota Rav4 with THAR-ONE-TOY8 Installation EVO ONE

I'm having trouble reading the diagram on the online installation guide. Could you simplify this for me please?
Login to reply View 1 answer(s)

16/11/2019

 Audi Brandon Talaski (130Pts.)

0

EVO ALL will not start vehicle

everything should be hooked up correctly and also programmed correctly. when i go to start the vehicle with the lock button it will not start. Everytime i press the lock button the blue light flashes on the evo, so it blinks 3 times when i try to start the vehicle because i am pressing the lock button three times and the vehicle does not start. The vehicle will however start when started normally with the key.
Login to reply View 1 answer(s)

16/11/2019

 Jeep william perks (130Pts.)

0

2018 wrangler light stays solid blue through all steps, so it wont program

unit will not proceed past 1ST step light stays solid blue
Login to reply View 1 answer(s)

12/11/2019

 Honda Xavier Bolivar-Hazboun (160Pts.)

0

No way to remote start 2005 civic via fortin products?

Hey, To my knowledge, the EVO-ALL and EVO-ONE only work as an immobilizers on 2005 civics. I'm a bit confused as to what products I would need to remote start my civic as there doesn't seem to be anything in the fortin lineup capable of doing it. My whole plan was to install an evo start 2 but that doesn't seem possible. Can anyone confirm?
Login to reply View 2 answer(s)

03/11/2019

 Jeep Levi Kudrna (240Pts.)

0

What firmware for 2015 Jeep Cherokee?

I have an EVO-ALL with T-harness for a 2015 Jeep Cherokee. I'm having problems programming it to the vehicle. The lights on the unit aren't flashing per the instructions. I have firmware 68.01 as this was recommended in FlashLink. While troubleshooting, I noticed the website said minimum firmware is 74.24. Should I flash it to the latest 74.xx firmware instead?
Login to reply View 2 answer(s)

03/11/2019

 Ram Danny Mennerick (170Pts.)

0

Red light will not change to blue during programming

Light will not change from red to blue during key programming
Login to reply View 1 answer(s)

03/11/2019

 Ram Danny Mennerick (170Pts.)

0

step 4 light stays yellow when key is inserted 2015 ram 1500 tip-key

when i insert the key, yellow light stays on and doesn't change
Login to reply View 2 answer(s)

02/11/2019

 Ford trevor gorniak (2230Pts.)

0

2012 Ford Explorer PTS

installed evoall stand alone with solace RF kit remote start works fine door locks wont work i tried grounding the purple wire on the evo all and still dont work the blue light on the evo all flashes when the remote is pressed but wont unlock the factory remotes work to lock and unlock the doors when remote started and the evo all blue light flashes when the oem remote is used guide 88721 software is .57 evoall service number is 001A06814763
Login to reply View 1 answer(s)

27/10/2019

 Ram trevor gorniak (2230Pts.)

0

Evo all programming 20019 ram 1500 push start

Install complete and verified go to program evo all and at step 5 instead of the blue light coming on the blue and red comes on checked everything twice called tech support and they said don't worry about it. i ignored the red being on and carried on to next step and all was ok. Has anyone else seen this issue i hope they repair this in the guides so installers dont have these issues
Login to reply View 1 answer(s)

09/02/2019

 Honda Raymond Brantman (130Pts.)

0

2009 Honda Accord remote start will not work

I used the suggested settings using flash manager and followed instructions on connecting to vehicle and car will not remote start with OEM key (3x). Red light blinking when car is armed and blue lights blink when i hit the lock key each time and nothing starts.
Login to reply View 1 answer(s)

02/02/2019

 Dodge Todd Karlen (130Pts.)

0

Blue light shuts off when turning key to on position

2008 Dodge ram the blue light shuts off when I turn the key to the on position.
Login to reply View 1 answer(s)

No results

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask a question

TECHNICAL SUPPORT

Search through our most popular products and installation topics available in our Question & Answers section.

Learn more
Download our step-by-step troubleshooting guides app available for both iOS and Android or browse through our desktop version.

Learn more
Access the industry’s largest online wiring diagrams & photo database. A free token is provided in every EVO-SERIES box.

Learn more
You did not find the information that you were lookingfor? Ask us a question by filling out the technical support form request. A product specialist will answer you shortly.

Learn more
From state-of-the-art vehicle remote control and connectivity solutions to premium technical support, learn why you should choose Fortin products.

Learn more

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue